MEMs based barometric pressure sensors are quite common these days. The Qwiic Pressure Sensor with the MS5637 shines by being the most sensitive barometric pressure sensor we have come across. It is capable of detecting the difference in 13cm …

Arduino MKR WAN 1300 has been designed to offer a practical and cost effective solution for makers seeking to add Lo-Ra connectivity to their projects with minimal previous experience in networking. It is based on the Atmel SAMD21 and a Murata …

These cables are ideal for connecting wearable microcontrollers like the Adafruit Gemma or education platforms like the micro:bit (or the Kniwwelino) to a clipboard! On one side is a high-quality pin, on the other side a handy mini alligator …

This battery holder connects 3 AAA batteries together in series for powering all kinds of projects. We spec'd these out because the box is slim, and 3 AAA's add up to about 3.3-4.5V, a very similar range to Lithium Ion/polymer (Li-Ion) …

Build Gamora, from the Avengers: Infinity War movie, with this fun LEGO® BrickHeadz construction character with vibrant green skin, detachable sword and display baseplate.Ages: 10 - 99 Pieces: 136Build your own LEGO® BrickHeadz version of …

This fancy and ultra-adjustable PCB holder was recommended to us by Collin, who is not only a master at soldering but also has impeccable taste in furnishings, so we just had to get these in stock. Not surprisingly, we agreed with Collin that …

We've been looking for a display like this for a long time - it's only 1.5" diagonal but has a high density 220 ppi, 240x240 pixel display with full-angle viewing. It looks a lot like our 1.44" 128x128 display, but has 4x as …

The super-villain emerges from the grand entrance in a wicked, souped-up robotic spider. "Ah hah, so you've discovered my secret compound, Ms. Croft. How unfortunate for you that I control all the egresses..." She …

The TFMini is a ToF (Time of Flight) LiDAR sensor capable of measuring the distance to an object as close as 30 centimeters and as far as 12 meters! As with all LiDAR sensors, your effective detection distance will vary depending on lighting …

The NFC-RFID Expansion Board will bring a new world of exciting functionality and application to your Omega2 module. As with other expansions, it will plug into your Onion Expansion, Arduino or Power Dock, and provide you with both NFC and RFID …

This 300 mm Y-cable is typically used to connect two servos to a single servo port on an RC receiver or servo controller. It has a single female JR connector connected to two male JR connectors, which means it is compatible with almost all of …

This pre-built Edge Connector Breakout Board for the BBC micro:bit gives access to all the important pins on the bottom edge of the BBC micro:bit. Looking to do more with your BBC micro:bit? Unlock its potential with this pre-built version of …